The NEW Magnescale MG80 Interface Modules allow you to hook-up 64, 255, and 65,535 gauges (depending on the model). The Magnescale DK800S, DK, and DT series gauges can be hooked-up via EtherNet, EtherNet/IP, EtherCAT, and PROFINET to a PC or PLC.
The MG80-CM is a 1 axis counter module that works along with the main module. This counter module is for the DK800S, DK, and DT series gauges. One of these counter modules will be needed for every gauge used. A MT13 interpolator is required to hook-up the DT series gauges to the module.
All Magnescale MG80 Interface Modules have resolution selection (0.1 to 10 um), reference point setting, reset, preset, master preset, current value / maximum value / minimum value / P-P value output of each axis, calculation function (2-axis addition and subtraction), comparator function (up yo 8 set of 2 or 4 steps can be set). The MG80’s can be mounted by a 35 mm DIN rail mount. The maximum cable length that can be used is 20 m (shielded CAT5e recommended).
The MG80-NE has an EtherNet (TCP/IP) 100Base-TX output. There can be 16 MG80-CM units connected to each MG80-NE, and up to 64 gauges can be hooked-up (via link connection).
The MG80-EI has an EtherNet/IP output. There can be 16 MG80-CM units connected to the MG80-EI, and up to 255 gauges can be hooked-up (via link connection).
The MG80-PN has a PROFINET output. There can be 16 MG80-CM units connected to the MG80-PN, and up to 255 gauges can be hooked-up (via fieldbus IP address configuration).
The MG80-EC has an EtherCAT output. There can be 16 MG80-CM units connected to the MG80-EC, and up tp 65,535 gauges can be hooked-up (via link connection).
The Magnescale MG80 Interface Modules allows the data that is collected from the measuring unit to be sent to a PLC or PC via EtherNet, EtherNet/IP, PROFINET, EtherCAT fieldbus or RS232.
